Former VWDieselParts.com Forum

Does anyone know if the exhaust pipe sizes for the mk1 and mk2 diesel is documented in the Bentley manuals? I looked for the mk2 in the Bentley and found nothing. My next step is to go thru the mk1 Bentley.

Check for Binswanger Glass location in your state. Then cover 22 states. HTH

Sorry, fatmobile. Will not happen again. I bought a 5/16" brass hose barb for mine. I have not done mine yet, on my recently acquired mk2 Jetta, because I do not know where the wires go. I think the electrical connector is on top of the separator tank But I still have not dropped the tank to se...

I just got a mk2 that had vented rotors, but are of the Lucas 54/Girling type. The rotors are 10.1" (256x20mm) and I ordered two original part number sets of pads, 191615151A (for 16mm thick pads for 20mm vented rotors) and 191615151B (for 19.5mm thick pads) Both sets came to me with 19+mm thic...

I found the following in my stash:
a) one (1) stamped a/c pulley 068 105 255 H
b) one (1) cast a/c pulley 068 105 255
c) one (1) crank pulley 068105 263

Will sell for both for $30.00 shipped. Let me know which a/c pulley you want.

What do you use to replace the breather hose with spring inside that connects between the filler neck and the fuel tank on diesels? The size is 15.5 mm x 2,5 mm x 850 mm. The length is actually about 18 inches. Closest fuel resistant line I have found is 5/8", but the walls are too thick. The o...

I have a 1.6L camshaft for $30.00 plus shipping.

See? The old saying about "Can't see the forest for the trees" still applies. I have looked at the eroded area for so long, that it never dawned on me to check it with a gasket, even when I was using a marker to isolate the area. Quantum-man, thanks for the wake up call. ken

I sorta knew that it probably could be fixed, but at what cost? No experience in that area. The head looks relatively unused, valves look brand new. Pre-chambers still show concentric circles on the surface and the edges are machined, not a sharp edge like it had been planed. The head was off an eng...

Have a non-planed, 1.6L head, 068103373M, Sep 27, 1984 with 30 mm pre-cups. There are no crack between valves; however, there is erosion on the manifold side by number 4 cylinder. I used red felt tip pen to highlight the erosion and am including links to pictures. Primary question is: can this head ...

Sent you a PM yesterday with a list of relays I have available. Did you get it?

Here are the part number for the three (3) hole pulleys in our stash:
068 121 031 B 5 3/8 OD 1 1/2 ID

027 121 031 A 4 1/8 OD 1 1/8 ID

Also have some four (4) hole pulleys:

055 105 255 J

068 105 255

Let me know if any apply or you need pictures. ken

Shipped today, should arrive by Wednesday.

Never received your PM or response to my PM. I have the mount for $15.00 plus shipping.

Sent PM