Former VWDieselParts.com Forum

I have a 1mm over 1.6 TD hydraulic motor, mildly ported head, pump upgraded to 1.9 cam plate-10mm head-internal tweaks!

I want to add a 210mm clutch set-up BUT no clear information on line.

I see a Sachs kf785-02 will work but no definition if is uses one 7mm dowel pin or 2 6mm dowel pins!
I have ...

I have a 1986 1.6TD turbo set-up air side is marked Garrett and I see an M24 on it..Stock 1986 Hydraulic motor turbo off of original motor.... What turbo kit do I need---- Can't read the plate. $ bolt plate to exhaust- two bolts are closer together then the other two. 4 bolt flap on waste gate...

I ...

just didnt want to crack the housing...thnx

What is the part number for a Bilstien turbo diesel oil pump. I know that 1.6TD run a bigger geared pump for higher flow circualtion.

I recently bought one but Im not sure if it is the right one for a turbo build.

HERE are the numbers on the box Bilstein
028 115 105G
46901743
120310045

thanks!

I scored a really tight 18T Volvo turbo off of a vehicle at the bone yard. This turbo runs both coolant and oil through it, so I believe its a bearing turbo. It does not appear to big for a 1.6 but not sure. Just kind of kicking around putting this on if I can figure out how to make use of the weird ...

awesome! I feel more confident now that I see some numbers.


thanks

Thanks for the input.

I believe I will put the AUG back in it . The guy I got the car from used it as a long distance daily HWY commuter car, but did not go up and down hills to get there. Then the head started leaking so he went and bought a TDI (lucky him).

Fatmobile- There are a few local ...

I am getting ready to pull the motor and transmission out of an 85 Jetta due to a weaping head gasket. I have a rebuilt Turbo Hydraulic shortblock I am going to go back with, ARP, 1.9 metal head gasket BUT I found out this vehicle has a GASSER TRANS. I had a 1.9 cam plate put into the IP and plan on ...

not, I have posted.

Got it! my cousin told what to try!

Screwed the rod in the rest of the way and added a few washer to set the master off of the booster...My has the seal in the booster "No O-rin" on the master cylinder..so it worked fine.

I NOW HAVE BRAKES AND ACTUALLY HIT 5TH GEAR...this thing must have been ...

I have an 81 Caddy that I bought several months back. Since then I have replaced the front calipers, initially I put on braided SS lines up front~but went back to NEW front rubber brake lines, new master cylinder (leaking between booster), brake pads. This thing has been whipping me up one side and ...

ONE down and one to go!

First i pulled the return outlet on the pump and checked the orifice on the banjo- it looked good and no restriction. Then I blew a little air down the return line and heard bubbles in the tank. Then I pulled the fuel supply line at the tank no the Rabbit truck and only a ...

Fatmobile___
thank you so much I am going outside in a minute to look at those two things! check valve and sender.

how do you get to the filter screen in the tank?

I took the water seperator out because the lid was leaking! bypassed with hose
thanks again

thanks for the info! just needed outside input in case I was missing something simple. I am still elarning these vehicle. I left older Mercedes behind to get a little better mileage.