Former VWDieselParts.com Forum

Rich where in mid michigan are you??
later
Justin

yeah i need to get a vacuum gage on it, i did put a copper coil around the veg filter to heat it up and reduce the amount of cold veg oil, so right now there is about 6 inches of un heated line

later
Justin

put in the wvo system, and them if you get time to make the biodiesel you can just mix it in with your diesel tank, and eventually you can just run off of both and not have to buy fuel, well methanol or ethanol and lye

good luck
Justin

yeah i just had some wires pinch somewhere so it just grounded out, i am going to re run my wires tonight or tomorrow and get the system up and running again.

i am using the 6 port pollak setup

later
justin

no i mean the tank selector (to switch from the diesel tank to the WVO tank) its an electronic selenoid valve, i just goback from alaska so i will dig into it tonight and see what i can figure out

later
justin

hey guys i need to check to see that my wiring is still good to the fuel tank selector but I am suspecting that it might have went bad, if it did then i will have to fight with JC Whitney to get a new one, where do you guys get your selectors for you WVO conversions.

later
Justin

after talking about doing it for quite some time, i finally got everything hooked up last night and tested it this morning on the way into work, it took a little while to get up to temp but i was doing a lot of stop and go driving, i switched it on for a little while and it seemed to run alright, ma...

Hey guys I was wondering where you run your hose within a hose lines on a rabbit pickup, Fatmobile I am looking to you for advice, I dont think that i want to run them below the truck since my exhaust is in the way of the tunnel and I dont want to scrape something along the bottom and rip my hoses o...

What in straight vegetable oil eats away at heater hose, i know that with biodiesel its the methanol or ethanol that eats away at the hose, but when running just straight veg oil the only difference is the liquid and not the temperature since you would otherwise run coolant through it. If I remember...

Watsongs, where are you located and would you be willing to sell any of those tanks that you have been accumulating?

thanks,
Justin

I am preparing to install my own WVO tank and want to do the hose within a hose to get the coolant to and from the tank plus it will make for a cleaner install (in my opinion)

What do you guys use for the outer and inner hoses as well as unions and compression fittings?

thanks in advance
Justin

HARWAL

Justin,

The following item:

17 x 28 x 07ADL VITON $12.41 ea. Minimum 4 pcs

Let me know!

Regards,

Rob Andreoletti
HARWAL

thanks I just looked up the website for the Viton seal and I should have a price quote by the end of the day, the website is www.harwal.com
I hope this isnt a competitor to jack, this place only sells rubber and rubber like seals

where did you get the viton seal for the injection pump?

what kind of reading would it give you before and after it is clogged?