Right now however, I'm stuck.
![Sad :(](./images/smilies/icon_sad.gif)
Question 1: In the picture below, do the ball bearings need to be pressed out? I tried hammering them out and pressing them with a vice, no luck. Do they have to be taken out or is there something else that can be done? Couldn't find exact info with the search.
![Image](http://i96.photobucket.com/albums/l163/Op-Ivy/Injection%20Pump%20Rebuild/P1010031.jpg)
Question 2: Again, in the pictures below, is the bearing supposed to have a bit of play? That is to say, when the shaft is in the bearing, should there be a small amount of play? I think that the timing belt is pulling down on the IP gear which is causing the belt to slide to one side and become slightly frayed/worn on the edge.
Also, is this bearing pressed in? Is it hard to get out or get a replacement?
![Image](http://i96.photobucket.com/albums/l163/Op-Ivy/Injection%20Pump%20Rebuild/P1010043.jpg)
![Image](http://i96.photobucket.com/albums/l163/Op-Ivy/Injection%20Pump%20Rebuild/P1010042.jpg)
PS. I would not be able to do this rebuild without the help and contributions of everyone on this forum. We have a great community here and it is amazing how much information has been shared. Thank you to all!!
-Matt