Governor screw

Upgrades to the 1.5, 1.6 and 1.9 engines that make them go farther or faster
Post Reply
Estdub
Glow Plug
Posts: 17
Joined: Tue Jun 28, 2011 3:16 am
Location: Estonia(europe)

Governor screw

Post by Estdub »

Hey.

After rebuilding my Injection pump my car doesnt rev as it used to do. it idles fine. It pulls happily to about 60 km/h and then the power stops suddenly, just like someting is cutting the fuel... .I did unhook the wastegate from the turbo and it acted the same.I turned the max fuel screw in and the result was just more smoke in all revs. also tried to turn the idle screw and max throttle screw. The only thing i havent turned yet is the governor screw. So the question in here is: what does that screw regulate and where to turn it to get my revs back. Also, how can i turn off the original bov ?


Ingmar
Fatmobile
Global Moderator
Posts: 7574
Joined: Wed Oct 30, 2002 10:28 pm
Location: north central Iowa

Re: Governor screw

Post by Fatmobile »

Got the accelerator lever on the right splines?

When floored, the lever makes it all the way to the high RPM stop?

Unscrew the blowoff valve screw and dropp a small allen head bolt down in there, then screw the plug back in tight, might be a spring that needs removed.
'91 Golf gasser converted to a 12mm pump, M-TDI.
'84 1.6TD Rabbit with a VNT-15 turbo, still setup to run on vegetable oil.
'84 GTI with 1.7TD pistons and intercooled.
2003 TDI wagon
2000 TDI Jetta.
euro4life
Glow Plug
Posts: 1
Joined: Wed Oct 29, 2014 8:43 pm

Re: Governor screw

Post by euro4life »

Fatmobile wrote:Got the accelerator lever on the right splines?

When floored, the lever makes it all the way to the high RPM stop?

Unscrew the blowoff valve screw and dropp a small allen head bolt down in there, then screw the plug back in tight, might be a spring that needs removed.
Can you explain more on how to get to the right spline. I am having a similar prob. I took the top off and forgot to mark it. I started it the first time and it idled fine but would not rev when floored it barley came off idle. So i went in and took the lever off again to adjust it and started the car and it went wot. So im thinking it has to be aligned. Thanks!
Fatmobile
Global Moderator
Posts: 7574
Joined: Wed Oct 30, 2002 10:28 pm
Location: north central Iowa

Re: Governor screw

Post by Fatmobile »

Just one spline went from low RPM to high?
The max fuel screw will also keep the RPMs low if turned out too far.
'91 Golf gasser converted to a 12mm pump, M-TDI.
'84 1.6TD Rabbit with a VNT-15 turbo, still setup to run on vegetable oil.
'84 GTI with 1.7TD pistons and intercooled.
2003 TDI wagon
2000 TDI Jetta.
Post Reply