so....I'm putting the cam timing gear on the cam shaft, and there's a keyway slot in it, and there's a rusty spot on the gear internal surface where the two were together before.....but, I can't find a keyway pin in my removed parts stuff.....and, I'm pretty meticulous about keeping stuff together (not loosing parts)...
No key on the camshaft. Just a keyway cut there to fool people. Put it together as is. Clean up the rusty stuff on the cam and sprocket mating areas though, they should me immaculate.
coke wrote:No key on the camshaft. Just a keyway cut there to fool people. Put it together as is. Clean up the rusty stuff on the cam and sprocket mating areas though, they should me immaculate.
AWESOME....thank you so much.....I thought I was loosing my mind about misplacing a pin!
I'll clean that internal surface up very well, and get the belt on next!
Be a good idea to leave the camp sprocket loose on the taper some so when you tension the belt up, it doesn't move the cam. They have a tendency to do that when you have had the pulley off.
As long as the crank and cam are at TDC, you're set. The pump has a mark in the sprocket that can be lined up with the hash mark on the plate it attaches to to get it in the ball park, and finite timing can be done after the engine is started by advancing or retarding the timing.