Page 1 of 1
IP Mounting bolts/pump bracket?
Posted: Sun Jan 27, 2008 7:19 pm
by surfing07
I need to know what kind of bolts to use to mount my IP bracket, and the IP to the bracket? I have 6 allen bolts, and not sure where they go? The IP bracket seems to be the logical solution, but when I put the allen bolts in they stick out reall far and will seem to get in the way of the timing belt. Any help much appreciated. Thanks, E
Posted: Sun Jan 27, 2008 11:15 pm
by CoolAirVw
I took pics of "where stuff goes". Here's the photobucket link.
http://s91.photobucket.com/albums/k286/ ... ff%20goes/
And heres one pic.
Posted: Mon Jan 28, 2008 3:20 pm
by surfing07
Thanks for the photos, it seems your IP mounting bracket is different then mine. and from the looks of the pics the 6 longer allen bolts are not used for the bracket. are the two short allen bolts supposed to be used on the back end of the IP mounting bracket like in the pics? Thanks. E
Posted: Mon Jan 28, 2008 4:05 pm
by 82vdub
There are allen head bolts in that pic for the IP bracket. When I redid my motot mounts a couple months ago, my IP bracket had allen head bolts holding it on to the motor.
Posted: Tue Jan 29, 2008 1:59 am
by Fatmobile
the 6 longer allen bolts are not used for the bracket. are the two short allen bolts supposed to be used on the back end of the IP mounting bracket like in the pics? Thanks. E
6 longer allen bolts sounds like intake manifold bolts.
The 2 short ones might be for the injection pump bracket.
If his doesn't look like yours,... you might be working on a Rabbit,... his is an A2 Jetta.
Should be 4 allen bolts holding the injection pump bracket to that end of the block. The 2 upper ones also hold a small bracket that the timingbelt cover bolts too... on the A2 picture above it's just an extended bolt.