turbo support bracket?
Moderator: Fatmobile
turbo support bracket?
I have a westie with a 1.6 turbo and the turbo needs support brackets or something because it keeps vibrating the exhaust nuts loose. I have tried double nuts on the exhaust mainfold and no luck. What have other folks done to prevent this? I do not know enough to tell what kind of turbo I have.
-
- Glow Plug
- Posts: 16
- Joined: Sun Dec 10, 2006 1:28 pm
This is my solution, based on the OEM TD Van brace. The OEM brace mounts near the center of the engine block and creates a less than ideal angle for controlling exhaust flex, plus there just aren't that many used pieces kicking around in the junkyards here.
My support bracket bolts to the lower left bellhousing bolt at the engine end and to a plate sandwiched between the exhaust flange and the turbine housing (OEM uses a wide exhaust flange to accomplish the same thing).
Chris
Pardon the dust - I had to get dragged - backwards - for about a quarter mile yesterday through deep soft sand that the little skinny tires just couldn't handle (even at 15 psi).
My support bracket bolts to the lower left bellhousing bolt at the engine end and to a plate sandwiched between the exhaust flange and the turbine housing (OEM uses a wide exhaust flange to accomplish the same thing).
Chris
Pardon the dust - I had to get dragged - backwards - for about a quarter mile yesterday through deep soft sand that the little skinny tires just couldn't handle (even at 15 psi).
'82 TD Westy
'81 NA Caddy
'81 NA Caddy
support bracket for turbo
Thanks for the response. On the flange with the plate do you have to change the length of the studs on the turbo, I assume that is a stud, one of mine is broken off, how hard is it to take those nuts off without busting them? Thanks again for your help.
-
- Glow Plug
- Posts: 16
- Joined: Sun Dec 10, 2006 1:28 pm
I used longer than stock studs, knowing that the 1/2" exhaust flange and the 1/4" bracket would be too thick for the stockers - plus I think the originals were in poor shape and needed to be replaced anyhow.
Soak the area with Kroil or similar, at the point where the stud enters the turbine housing, maybe run it through a couple of rapid heat/cool cycles and hopefully you'll be able to back the studs out by turning the nuts.
Welding a nut to the broken stud is one good way to get that one out.
Chris
Soak the area with Kroil or similar, at the point where the stud enters the turbine housing, maybe run it through a couple of rapid heat/cool cycles and hopefully you'll be able to back the studs out by turning the nuts.
Welding a nut to the broken stud is one good way to get that one out.
Chris
'82 TD Westy
'81 NA Caddy
'81 NA Caddy