1.6 engine block

[tl]

1.6 engine block with crank and intermediate shaft. Crank and Wrist Pins are tight. Pistons have slightest erosion at the same place on top of each (water in fuel at some point?). These pistons have had old rings removed and are good to go. Estimate .001 inch ridge on one cyclinder bore. You will need set of standrd rod bearings. This is a solid lifter version not sure of 11 or 12 mm bolts ( I did some research at one point decided it was a 12mm?) Asking $175.00 + shipping, located in Des Moines IA. I have shipped one these UPS. tl792@yahoo.com